|
24-bit Analog-to-Digital conversion of analog inputs: |
96kHz sample rate |
|
24-bit Digital-to-Analog conversion of digital sources: |
96kHz to analog 7.1 speaker output |
|
24-bit Digital-to-Analog conversion of stereo digital sources: |
192kHz to stereo output |
|
16-bit to 24-bit recording sampling rates: |
8,11.025,16, 22.05, 24, 32, 44.1, 48 and 96kHz |
|
ASIO 2.0 support: |
16bit/44.1kHz,16-bit/48kHz, 24-bit/44.1kHz 24-bit/48kHz and 24-bit/96kHz with direct monitoring |
|
Enhanced SoundFont support: |
Up to 24-bit resolution |
|
X-RAM: |
64MB |
|
Audio Performance (Rated Output @ 2Vrms, Typical Value) |
|
Signal-to-Noise Ratio (20kHz Low-pass filter, A-Weighted): |
Stereo Output 109dB Front and Rear Channels 109dB Center, Subwoofer and Side Channels 109dB |
|
Total Harmonic Distortion + Noise at 1kHz (20kHz Low-pass filter): |
0.004% |
|
Frequency Response (-3dB, 24-bit/96kHz input ): |
10Hz to 46kHz |
|
Frequency Response (-3dB, 24-bit/192kHz input): |
10Hz to 88kHz (Stereo only) |
|
Connectivity |
|
Line in / Microphone In: |
Shared 1/8" mini jack |
|
Speaker Out: |
4x 1/8" mini jacks |
|
Optical Out: |
TOSLINK1 |
|
Optical In: |
TOSLINK |
|
Intel HD Audio Compatible Front Panel Header: |
2x 5-pin |
|
Creative proprietary AND_EXT connector: |
Connects to one end of the AND_EXT cable. Connect the other end to the AND_EXT connector on the Sound Blaster X-Fi I/O Drive. |
|
Creative proprietary DID_EXT connector: |
Connects to one end of the DID_EXT cable. Connect the other end to the DID_EXT connector on the Sound Blaster X-Fi I/O Drive. |
|
I/O Drive Connectivity |
|
Auxiliary input: |
Two RCA jacks |
|
Headphone output and volume control: |
3. 50 mm (1/8-inch) stereo jack |
|
Microphone input: |
3. 50 mm (1/8-inch) stereo jack |